ELECTRICA
Original Article

Design and Implementation of Simulation Experiment of Electronic Communication System Based on MATLAB Software

1.

Department of Intelligent Engineering, Shijiazhuang Posts and Telecommunications Technology Vocational College, Shijiazhuang, Hebei, China

2.

Department of Information Technology, Gauhati University, Assam, India

3.

Central University of Punjab, Bathinda, India

ELECTRICA 2022; 22: 380-386
DOI: 10.54614/electrica.2022.21169
Read: 1155 Downloads: 452 Published: 22 June 2022

To solve the problem of large distortions in communication systems and high error of communication bits, MATLAB offers a test design method of simulation of communication systems based on software. First, the modulation of the propagation spectrum is performed at the receiving end of the communication signal. The structure of the electronic communication system will be established according to this communication principle. Then, the channel balancing design simulation will be performed using the transmission interval equalization technology. Simulation results show that the electronic communication code error rate of this method is between 0.2 and 0.5 and remains above 0.3. Therefore, the low bit error rate of the electronic communication system in this article, the good channel balancing ratio, and the high stability of the system are more valuable for practical use.

Cite this article as: Y. Li, Z. Zhang, W. Qu, N. Deb and M. Wasim Bhatt, "Design and implementation of simulation experiment of electronic communication system based on MATLAB software," Electrica., 22(3), 380-386, 2022.

Files
EISSN 2619-9831